HDD swap (21" OnDemand only)

Step-by-Step

  1. Power down the Wexer OnDemand, once completly shut down remove the power cable.
  2. Remove the I/O protection cover from the OnDemand. This is done by unscrewing the two Phillips screw from the bottom of the unit.
  3. When facing the OnDemand look behind the I/O Cover for a square HDD bay with a transparent snippet or puller, once you've found this rotate the plastic tab out of the way.
  4. Now grip the transparent snippet and give it a gentle but firm pull.
  5. Once ejected you'll see a HDD in the tray, remove this and save the tray.
  6. Now take the HDD tray from before and add the HDD you recieved into it and reinsert the tray back into the computer.
    1. Make sure you push it all the way in so that the tray is flush with the panel.
    2. Make sure to twist the plastic lock back into locking-position.
  7. Plug the power cable back in the OnDemand and press the power button (you should hear a small beep)
  8. Your unit has now successfully gotten a new HDD and should boot up in the Wexer software
    1. Please note that with the HDD swapped, that the Wexer Ondemand will need to setup and update the entire system again as it's reset to factory settings.